An independent plumbing guide for Dallas and North Texas homeowners. Not a plumbing company.Dallas and 25 nearby towns
214WaterDallas plumbing guide Call (855) 321-2979

Home / Plumbing problems / Pilot light won't stay lit

Water heaters · Dallas and North Texas

Water Heater Pilot Light Won't Stay Lit

On older gas water heaters, a small pilot flame lights the burner. When it will not stay lit, the cause is usually the thermocouple, a draft, or a gas supply problem.

Last reviewed November 18, 2026

Short answerFollow the lighting instructions on the label on the heater, and only if you do not smell gas. If the pilot lights but goes out when you release the knob, the thermocouple is the likely culprit.

Common causes

  • Thermocouple: this sensor tells the gas valve the pilot is lit. When it wears out or is out of position, the valve shuts the gas off.
  • Dirty pilot tube: a weak, yellow or flickering pilot flame may not heat the thermocouple enough.
  • Drafts: a heater in a garage or attic can lose its pilot in strong wind or when a door is left open.
  • Gas supply: if other gas appliances are also out, the problem is upstream of the heater.

If you smell gas

Do not try to light the pilot. Leave the house and call Atmos Energy at 866-322-8667 from a safe distance (Atmos Energy).

Newer heaters

Many newer gas water heaters use an electronic igniter or a sealed combustion chamber instead of a standing pilot you can reach. Those faults usually show as a blinking status light, and the code on the label tells the plumber where to start. See gas water heater repair.

Guides for your area: Dallas and 25 nearby towns.

Call (855) 321-2979